The Base/Plinth
Wherever you decide to install your hot tub, it is essential that a solid foundation be provided. Grass is not suitable. Please note: It is the responsibility of the customer to provide a suitable base that is flat, level and solid to prevent distortion from occurring. Any structural damage caused by improper base or base failure may invalidate manufacturer’s warranty.

An ideal base would be concrete 4 – 6 inches (100 – 150mm) thick. However, existing patio slabs and block paving may be utilized but must be flat, level and on a satisfactory sub base. Wooden decking is also a popular base. However, all bases must be able to take the weight of the hot tub plus the water and occupants. No form levelling by means of “packers” is acceptable.

NB. Bases must be prepared in plenty of time prior to delivery, thus allowing time for the concrete, etc to fully cure.

Service Access
Access is required around the hot tub for any future maintenance, ideally 24inches (600mm). If this is not practical then the area should be of sufficient size so that the hot tub can be moved when empty of water for access. The front has to be accessed for routine maintenance.

Electrical Supply
A suitably qualified electrician e.g. NICEIC registered, must carry out all electrical work to the IEE latest standards. The electrical supply will be permanently connected (hardwired) to a single-phase 240V supply from the earth leakage protected consumer unit directly to a waterproof switch. A clearly labelled 3 core (live, neutral & earth) armoured cable connected and isolated with the waterproof switch is required. The cable must be left at the side of the hot tub not underneath. The cable must have at least a 4 metre tail from the edge of the hot tub, for our installers to connect into the hot tub.
A Certificate of Approval to Part P of the Building Regulations will need to be produced. Failure to produce or to meet our terms will result in your hot tub not being connected to the electrics and we will be unable to commission the hot tub. The connection must be made at the consumer unit, as the installers will only connect at the hot tub end.

Please refer to your order form for the exact electrical requirements for your hot tub.

Hose Pipe & External Electrical Socket
A mains water supply with reasonable water pressure, connected to a garden hose must be provided by the customer to fill the hot tub. This should be flushed through to expel stale water. The hose can also be used to empty the hot tub when changing the water. A standard 240V 3 pin electrical socket is required within 10 metres of the base for lowering the hot tub.

Chemicals
A degree in chemistry is not required! A chemical starter pack can be purchased with your hot tub. The installers will explain the treatment required. They will also show you how to conduct the test with remedial actions. A hot tub water treatment manual will also be supplied with the hot tub.

Hot Tub Controls
The hot tubs all have digital controls and you will be shown how the main controls work by the installers. However an operation manual is supplied with the hot tub for you to be able to set the controls for your ease and comfort.

IMPORTANT NOTE:
Please be advised that return visits due to non-preparation of base, poor access, unsuitable ground or obstacles, unsuitable electrical/water supply, etc are chargeable at the Company’s hourly rate.

Manpower

We supply two people to install the hot tub on our hot tub cart.

They will NOT be able to remove the hot tub from the hot tub cart until it reaches the base.

If access is difficult, extra assistance by able bodied people will be required, which you will have to organize prior to the delivery.

If you are in any doubts with your access, we will be happy to arrange a site visit or look at photos emailed to us.

We hope this leaflet helps you prepare for your hot tub/portable hot tub.
If there are any questions or queries you may have, please ask us prior to delivery.

Unfortunately, we cannot advise on how to cope with the anticipation and excitement of owning a hot tub!

Hot Tub Dimensions Weights & Power Supply

Please see specification for the individual hot tub models on the website.